Stereo jack details. See colors painted on wrapping wire
On this pic its easy to see where to solder R-G-B wires !
The last one goes there on there other side of the board as it is much easier than trying to pass almost below the DS16510 !!
Precise location
Where to solder at higher magnification
Jack and resistor (470 Ohms)
Retractable sheath in place
Done !
Other end of wire on pin 2, //port (LPT) PC
Nylon rope ready to be glued with hot glue to
help later pulling from //port (should be done on both ends of plug, only
one shown here.
see previous page)